Thread: Discussion Hobby city epo ventus
View Single Post
Old Feb 27, 2011, 05:32 AM
olmod is offline
Find More Posts by olmod
Good Better Best quest.
olmod's Avatar
Australia, VIC, Langwarrin
Joined Apr 2004
10,589 Posts
I did remove the deck on the undercarriage and turn it over this allows all the parts to be glued in to finnned half of the fuselage.
The rods that are being glued into the motor mount are some 3mm fibre glass I had on hand is a reinforcing of my own conception.
I am using the HK bluebird BMS-306BB servos which fit the cavities and I have had no problems with them in the past plus an MG9 for the wheel.
olmod is offline Find More Posts by olmod
Last edited by olmod; Feb 27, 2011 at 05:56 AM. Reason: AT
Reply With Quote