View Single Post
Old Feb 19, 2011, 06:54 AM
Samjet is offline
Find More Posts by Samjet
Registered User
Samjet's Avatar
Joined Mar 2010
112 Posts
Quote:
Originally Posted by Arngeir Blakseth View Post
You can use the adapter that comes with the fan as it's bored for a 6mm motor shaft, however the OD is too small you will have to use the KnifeLiddle trick of adding a couple of layers of heatshrink to it, or just roll tape on it to bring the OD up to the bore of the Turbax rotor.

But, I think the best way to go is using this setup : http://www.rcgroups.com/forums/showp...&postcount=641

Contact details here : http://www.rcgroups.com/forums/showp...&postcount=665
Thanks Anrgeir

But it's 80$ for the components as i recall it plus shipping to Europe. Then the final fan would cost

Fan 25$
Standoff adapter 80$
Turbax rotor 40 $
Total 145$ minus shipping
Thats not cheap compared to a brand new
Turbax fan at 175 $

Still I am sure it would be the best solution with the standoff adapter but not cheap.
Samjet is offline Find More Posts by Samjet
Reply With Quote