Thread: Mini-HowTo Rhino ... some basics
View Single Post
Old Feb 19, 2011, 01:31 AM
Harpye is offline
Find More Posts by Harpye
Build it again, Sam!
Harpye's Avatar
Germany
Joined Oct 2004
4,096 Posts
Dave:

Scripting is fun ....

My last attempt about a 4 axis simultaneous milling app for dynamically cutting pins of crank shafts..... ( just a trial .... code generator exists but not yet the file generator video is created using fixed engagement to achieve the final pin diameter ... in the real loop the mill would engage about 0.5 to 1 mm stepwise to the pins diameter ... just some parametrization )

4 Axis Simultaneous Crank Shaft Cutting with Rhino 3D (0 min 22 sec)



By the way ... Thanks for the compliment!

Using a real Spript in RVB gives you much more possibilities... you even can structure your punch trough holes by stamps or doo other weird things ... I'm still far way from beein trough with it but the possibilities and potentials are great!!! and you are able tocreate new command buttons in the menue bar doing such tasks you programed before!!!
Harpye is offline Find More Posts by Harpye
Last edited by Harpye; Feb 19, 2011 at 01:43 AM.
Reply With Quote