View Single Post
Old Feb 15, 2011, 03:08 PM
frankg is offline
Find More Posts by frankg
Registered User
Joined Dec 2004
4,173 Posts
Remove the mahogany covering boards from laser sheet S9. The covering boards are very much over sized so they can be trimmed back after being glued in position on the hull. Line up the front of the right covering board on the center line of the deck with its back edge on the 1 1/4 mark. The covering board will run down the side of the deck and flush with side of the cockpit opening as it runs to and off the transom. Tape in position on the sub decking every 4 or so with masking tape and then mark the inside edge of the covering boards with a pencil line on the sub decking. This will give you the area to be glued when installing the covering board. (DWG#8)

frankg is offline Find More Posts by frankg
Reply With Quote