View Single Post
Old Feb 12, 2011, 03:51 PM
frankg is offline
Find More Posts by frankg
Registered User
Joined Dec 2004
4,173 Posts
With the batten angle cut at the stem post, proceed to glue the first chine batten in, starting at the stem post, and working back toward the transom gluing the batten at each frame as you go. Now take the opposite side chine batten and angle cut it for the butt joint at the stem post. Once fit glue it in as was done with the first batten with medium CA glue starting at the stem post and working back to the transom.

frankg is offline Find More Posts by frankg
Reply With Quote