View Single Post
Old Jan 31, 2011, 11:49 PM
finster is offline
Find More Posts by finster
Registered User
finster's Avatar
Michigan
Joined Feb 2006
502 Posts
I wanted to throw a new AA battery in to test voltage on charger and I noticed something that may be the prob...lostheli knows what Im talking about but for others...if you take off the clear cap and look at bottom of circuit board theres a silver solder ring that runs around the border which when you tighten the clear cap it pushes that ring against a thin lip inside charger housing...which is negitive side from battery...its possible the cap wasnt tight enough to make a good connection...I do get 5.36v now with fresh battery but dont know what voltage was before I tightened the cap...sorry for the long delay...Im testing it rite now...you can see the ring on circuit board here...bottom pic
finster is offline Find More Posts by finster