View Single Post
Old Jan 30, 2011, 07:52 PM
Aralan is offline
Find More Posts by Aralan
Registered User
Joined Sep 2010
25 Posts
I was finally able to extract the guts of the power supply from the chassis. I will cover the contact used to attach DC ground to the chassis in liquid electrical tape. The screws on the main board that attach to the bars leading to the hot plug board are pretty well covered in solder. There's also a lot of solder around them, so I may end up not removing them. My next step is to desolder and unscrew the hot plug board (at the hot plug board side, not the main board). From there I may either use screws to attach ring terminals to the bars, or go back to plan A and cut them down, and then solder leads on to what remains.
Aralan is offline Find More Posts by Aralan
Reply With Quote