View Single Post
Old Jan 28, 2011, 02:25 AM
CaptJac is offline
Find More Posts by CaptJac
Rotor Controller
CaptJac's Avatar
Aachen Germany
Joined Dec 2007
2,394 Posts
Tail-in hovering

The stability of your hover is only as good as your lift off. Practice lifting-off with as little rolling as possible. Hold a "tad" of right aileron before lift-off - and neutralize the aileron immediately after. Applying right aileron after lift-off is too late- you end up correcting as soon as you are air born. It takes a while to find that "tad" sweet spot - so be patient.


Sim speed and Model setup are at 100% - camera speed is 50% (controls zoom) - heading-hold gyro - linear rudder - 25% expo cyclic - collector pitch 0 +3 +6


----------------Click on the 4-arrows at bottom for full-page

Hovering tail-in.wmv (1 min 35 sec)
CaptJac is offline Find More Posts by CaptJac
RCG Plus Member
Last edited by CaptJac; Feb 09, 2011 at 12:36 PM.
Reply With Quote