View Single Post
Old Jan 26, 2011, 07:28 AM
Derek_S is offline
Find More Posts by Derek_S
Videopilot
Derek_S's Avatar
United States, NC, Charlotte
Joined May 2009
2,855 Posts
Quote:
Originally Posted by IBCrazy View Post
Ideally, the reflector should be round and not square. However I found this to be difficult, so I simply trimmed the corners from my square pattern. Really this makes little difference whether it’s round or square, but it keeps me from getting cut on the sharp edges anyway.

For my 1280MHz my reflector is 9-1/8” square
Out of curiosity, if a perfectly round one was made, would the diameter also be 9-1/8”? I may cut mine down closer to a circle, say octagonal?
Derek_S is offline Find More Posts by Derek_S
Last edited by Derek_S; Jan 26, 2011 at 09:02 AM. Reason: speelin
Reply With Quote