Slow Stick Legacy
View Single Post
Jan 16, 2011
, 09:08 PM
ɹǝsn pǝɹǝʇsıƃǝɹ - inverted!
USA, SC, Greer
Joined Jul 2008
A few build pictures...
View all Images in thread
I cut the #1 part for the CF rod and glued it first
Parts number 1,2 & 3 form three steps that make the wing parallel with the fuselage
The LE CF strip was a 1 piece .057" X .177" X 40"
The round CF tube I used was a 1 piece .157" OD X .098" ID X 40" (4mm X 2.5mm X 1016mm)
Use a really good tape on the underside of FFF for it to stick to the foam
The pdf plan (in the plan section) is full size. I used 1/16" holes, 1/8" on center. Use a punch to make a lead for your drill bit.
I used a 11X4.5 prop
I used this Hi-Max motor with a 20A ESC
Extra bracing on the LG wiithout adding much weight
I put a brace on the tail wheel
Last edited by DaDesign; Jan 20, 2011 at