View Single Post
Old Jan 13, 2011, 07:29 PM
clx1 is offline
Find More Posts by clx1
Registered User
Joined Dec 2010
25 Posts
Originally Posted by clx1 View Post

Huh, that is interesting. I was able to remove the datestamp on both however so that may be a good clue but there must be more to it.

Yes - so when I say the v1 cams may be "at risk", I mean that these cams might not be flashable by the user but could have been updated at the factory by flashing the EEPROM properly or simply had it replaced, as the vendor suggested to me to do myself. However, it sounds like the cams with no red wire going through a hole in the PCB have consistently been able to be flashed successfully by the user.

It would be fun to know if there is fact-based support for this hypothesis without having to brick too many v1 cams.....

clx1 is offline Find More Posts by clx1
Last edited by clx1; Jan 13, 2011 at 07:36 PM.