View Single Post
Old Jan 13, 2011, 06:29 PM
bikeman is offline
Find More Posts by bikeman
Registered User
bikeman's Avatar
United States, PA, Ephrata
Joined Dec 2005
512 Posts
Mounting tail surfaces

I glued the horizontal stab on with CA and kicker as the instructions mentioned. I usually use Goop or Gorilla glue but I figured CA would be more likely to pop off rather than tear the foam in the event of a cartwheel, possibly saving the fuse. We'll see. The vertical stab however, without much gluing surface area, I used Goop on. The mod I made to the vertical stab with the carbon reinforcement made a HUGE difference once it was all glued together. The extra length of carbon ribbon now buries itself in the fuse tying it all together nicely.
bikeman is offline Find More Posts by bikeman
Reply With Quote