View Single Post
Old Jan 13, 2011, 06:07 PM
bikeman is offline
Find More Posts by bikeman
Registered User
bikeman's Avatar
United States, PA, Ephrata
Joined Dec 2005
512 Posts
Tail servos

I made some more progress on the build. Next was marking and mounting the tail servos. Following the directions this is a painless affair. Using the instruction's recommendations for both servos makes sure the servo wires will line up with the internal channel that's precut that will lead the wires up to the canopy area. Nice. I chose to ditch the servo extension connectors and just use the pins and then shrink wrap them to hold them together. This makes fishing the wires up the channel very easy.

Mike
bikeman is offline Find More Posts by bikeman
Reply With Quote