View Single Post
Old Jan 13, 2011, 07:16 AM
pascalfd is offline
Find More Posts by pascalfd
Registered User
Joined Jan 2011
14 Posts
Quote:
Originally Posted by flarssen View Post
Never seen this, but I'm not on fw. 3.14. Did you see this prior to the upgrade?

Fred
Yes, It was at 3.13 when I got it and I upgraded hoping this would address the issue. What version are you on ? Maybe I can downgrad to it

When I check voltage, I press the 'inc' button to see the voltage read at the balance board then short press on the 'start' to go back. I don't use an external meter.
Manual states to use 'dec' button to return to general info screen, but in my case this cycles through additional settings and info like capacity limit, temperature, etc...
pascalfd is offline Find More Posts by pascalfd
Reply With Quote