Thread: Discussion Walkera 4F200 3 blade head
View Single Post
Old Jan 12, 2011, 03:01 PM
Xextriz is offline
Find More Posts by Xextriz
Registered User
USA, NC, Havelock
Joined Jan 2011
25 Posts
All the servos are plugged in to the right place, yes. Throttle up, throttle down, all the servos move the same up and down together and pitch seems to be consistent. I tried loosening the linkage arms, all 3 equally, that connect the swashplate to the rotor blades paddle. What that did was change the direction it wanted to fly when I pressed left down up or right. But the only problem with that, was the little plastic black thing that holds the top of the swashplate from spinning, it was not at a 90 degree angle when the blades were at 50% pitch. I believe that when the blades are at 50%, flat, no lift or anything, the servo arms and linkage and the plastic black thing should all be at a 90 degree angle as well as the swashplate being flat parallel to the helicopter correct?
Xextriz is offline Find More Posts by Xextriz
Last edited by Xextriz; Jan 12, 2011 at 03:10 PM.
Reply With Quote