View Single Post
Old Jan 09, 2011, 06:22 PM
bikeman is offline
Find More Posts by bikeman
Registered User
bikeman's Avatar
United States, PA, Ephrata
Joined Dec 2005
512 Posts
On to the fuselage

The same procedure is used to strengthen the fuse. Measure and cut a slot, then fit in carbon rods, then glue. Again I used thin CA and allowed plenty of time for it to cure. The end result was a straight and strong fuse. The fuse is about 2 inches thick. So far in the build I've followed the instructions other than substituting glue strategies a couple times.
bikeman is offline Find More Posts by bikeman
Reply With Quote