View Single Post
Old Jan 08, 2011, 02:08 PM
devinvagt is offline
Find More Posts by devinvagt
Registered User
United States, CA, Ukiah
Joined Jan 2011
271 Posts
newer n6

I have a different version of the n6 transmitter, FCC ID is V6KCY246.
No binding button! There is a space on the pc board where a button could be soldered in, but none was. There are three connections, labeled G,+, and unmarked. There are also five connections on the other side of the pc board which may or may not be important. I believe this is to set a pin on the main chip to high or low, but I don't know which is the normal setting and which the bind. Any help much appreciated.
Here are a few photos:
devinvagt is offline Find More Posts by devinvagt
Last edited by devinvagt; Jan 08, 2011 at 02:32 PM.
Reply With Quote