View Single Post
Old Dec 28, 2010, 08:49 PM
Prime_8 is offline
Find More Posts by Prime_8
Lawn dart pilot/builder
Prime_8's Avatar
N.L. Canada
Joined Jun 2010
2,337 Posts
did you fly today ?
i did taxi test of my LIL' and flew my choppers.

i figure you would be out for a glide .

important note on ballon bagging things ..
going back to my RC boat building .

1 try not to use too big a ballon ,water ballons and those small ones for custome baloon-grams ( in dollar store @ stavager across from wally for those in our town) .

you can place teh whoel servo in the baloon , fres water has never harmed one of my servos if i dried it out after a fly .. but that was my old big 2oz servos .LOL
but small ones will fit into small ballons just streach em over and press fit horn on , before (if) you put hold down screw in .
it will be a tight fit .. and you cannot take it off and replace , if you do use anew ballon .
- learned that on my sub .

NOTE ! place 1 or 2 beads of sillica gell in the ballon ..
as condensation will form on inside ofthe ballon , and usualy on metal pars like board and wires.
the sillica will lock an moisture that gets in away and eat the condensation .

same should be done with RX if possible , but the new RX's have small antene on them .
so could be a PITA to do. LOL
Prime_8 is offline Find More Posts by Prime_8
Reply With Quote