View Single Post
Old Dec 28, 2010, 04:23 PM
Prof100 is offline
Find More Posts by Prof100
Registered User
Prof100's Avatar
Canton, Michigan USA
Joined Jul 2007
16,807 Posts
Quote:
Originally Posted by ChanceCarroll View Post
Thanks! I whipped up a connector, do I connect the plug to the IDset pins? if so should the light change colors?

It's a 6 channel rx and a 4 channel tx if that matters...

Thanks again! If I can get this fixed I still have time to try it today!!!!
Blitz is notorious for NOT sending binding instructions for the 2.4 radios. There are a couple they offer. Below is for one of the radios. The below took be two weeks to get from BH.

BlitzRCWorks MC4DF 2.4GHz Radio Bind Process
*Before performing the bind process, please make sure that your lithium polymer battery is fully charged and you have installed fresh AA batteries into your transmitter.

1.) Plug the bind plug into the ID SET CH on the receiver.
2.) Plug the battery into the unit.
3.) Make sure the throttle stick and the throttle trim are both in their lowest down positions on the transmitter.
4.) Hold down the “Bind Set” button on the transmitter. Continue holding the button down while you power up the transmitter and after the transmitter is on.
5.) While still holding the “Bind Set” button down, remove the bind plug from the receiver. Wait for about 5 seconds before proceeding to step 6.
6.) Release the “Bind Set” button on the transmitter.

The bind process is now complete. Happy Flying!!
Prof100 is offline Find More Posts by Prof100
Reply With Quote