Thread: Discussion Walkera 4F200 3 blade head
View Single Post
Old Dec 16, 2010, 10:21 PM
ri0grand is offline
Find More Posts by ri0grand
Addicted Again
Wylie TX
Joined May 2009
371 Posts
Quote:
Originally Posted by rew-7 View Post
Not sure about the min of only 51%-I take it you know about rate and HH modes and this is as low as you could set. Maybe this Rx only runs in HH, that a new one on me though as you usually use rate to set up.

My limited knowledge would say stick with those settings as it sounds like thats the optimal. When I get mine I'm running all non Walkera on servo's for both tail and cyclic so may not get the same results anyway. If I can get a higher gain I'll let you know my set up.
When I go below 51% the gyro doesn't seem to react to yaw at all. That's why I said it seems like the min value. I figure the number is relative and not necessarily and absolute value that has the same meaning from one gyro to the next. I am not sure if it can be run in rate mode or not.
ri0grand is offline Find More Posts by ri0grand
Reply With Quote