Thread: Discussion Walkera 4F200 3 blade head
View Single Post
Old Dec 16, 2010, 05:43 PM
rew-7 is offline
Find More Posts by rew-7
Registered User
rew-7's Avatar
UK, Leeds.
Joined Mar 2009
398 Posts
Quote:
Originally Posted by ri0grand View Post
I moved the ball in on the servo arm in to give the servo more swing. I was able to get the gain up to 68% before it shakes. I am running it at 66% just slightly below when the shake starts. The min gyro sensitivity seems to be 51% This gives me 15% above that which should be safer. I could move the ball in one more hole but the push rod angle isn't optimal any more.
Not sure about the min of only 51%-I take it you know about rate and HH modes and this is as low as you could set. Maybe this Rx only runs in HH, that a new one on me though as you usually use rate to set up.

My limited knowledge would say stick with those settings as it sounds like thats the optimal. When I get mine I'm running all non Walkera on servo's for both tail and cyclic so may not get the same results anyway. If I can get a higher gain I'll let you know my set up.
rew-7 is offline Find More Posts by rew-7
Reply With Quote