View Single Post
Old Dec 15, 2010, 08:22 PM
SadSack is offline
Find More Posts by SadSack
Registered User
United Kingdom, Bristol
Joined Aug 2008
1,829 Posts
Quote:
Originally Posted by helidave1 View Post
Hi again,
The pull up resistors give me a clean input signal but I must have a timing issue somewhere. The scope shows me a group of three pulses followed by a gap and then three more. When I operate a channel on the TX the Pulse starts to expand then the group changes to a group of two or one dependent on the channel I am playing with.
I should point out that I have left the fuses on default which I believe gives me 8mhz but looking at the scope, maybe I am mistaken!

As before, any help or pointers gratefully received.
David
I had a few problems with the ouput signal and it turned out to be my signal was inverted. So added a few extra parts to invert signal and worked great and i'd done nothing wrong. I'm using Futaba gear but may apply to UK spektrum gear?!.
SadSack is offline Find More Posts by SadSack
Reply With Quote