View Single Post
Old Jan 06, 2004, 03:55 PM
RC Man is online now
Find More Posts by RC Man
A man with too many toys
United States
Joined Feb 2001
19,587 Posts
I did this mod and it only costs about $5-10 depending on where you get the bearing. You need a 13x3x5mm shielded bearing and 3mm screw (I forget the length). Just ream out the hole in to fit the bearing. You donít have to ream the hole much. I used a small knife and was finished in a few minutes. Very simple and works great.

BTW, I got a good deal on 13x4x5mm bearings so I used a piece of 4mm brass tube between the bearing and screw with a little thread lock and have never had a problem since.
RC Man is online now Find More Posts by RC Man
Reply With Quote