Thread: Discussion Walkera 4F200 3 blade head
View Single Post
Old Dec 03, 2010, 08:39 PM
desertstalker is offline
Find More Posts by desertstalker
Registered User
Australia, VIC, Melbourne
Joined Feb 2010
2,088 Posts
Quote:
Originally Posted by zadaw View Post
The problem is that I am still using my 2801pro to control to Trex 450 and 250. Obviously, I will have to watch this carefully.
I dont know that there is any evidence to support the 2801 being any worse than a dx6 in terms of signal quality AFAIK it uses a similar spread spectrum technology and the radio chipsets are reported to be of good quality. There are too many variables to any wireless link for blame to fall on a TX design without a strong pattern of failures.

The only issue the 2801 has is its programming oddities (eg. resetting a model changes the stick mode on ALL of them to mode 1 and resetting a model sets all throttle directions to normal) these should be fixed but shouldn't cause crashes if you are careful when changing settings.
desertstalker is offline Find More Posts by desertstalker
Reply With Quote