View Single Post
Old Nov 27, 2010, 02:46 PM
deadduck is offline
Find More Posts by deadduck
Registered User
Manila Ninoy Intl, Philippines
Joined Nov 2001
1,353 Posts
Quote:
Originally Posted by angelfood View Post
I'm finding that when installing the horizontal stabilizer (1) there is a small block inside the fuse, at the leading edge, which results in a slight gap at the fuse and leading edge, when, (2) the "slot" is used to locate the trailing edge.

Is this right?

Why is that block inside the fuse?
angelfood, you probably know this already, but it might help someone just starting their build.

The horizontal stab has a notch at the leading edge, which is covered over.

It indexes to the little block.

Very tight fitting, I almost feel that it does not need glue. Will just put a little on edges once it's centered.
deadduck is offline Find More Posts by deadduck
Reply With Quote