Thread: Discussion HobbyKing Fox EPO Glider 2.32M
View Single Post
Old Nov 22, 2010, 08:48 PM
Helitime is offline
Find More Posts by Helitime
Registered User
Pickering Ontario CANADA
Joined May 2010
842 Posts
Continuing tail mod: Glued all the tail plastic bits with foam safe C/A, adjusted the pin height and glued it in tight. The stab. now slips into place and locks down good and tight. No way to connect the "z" bend though (inside the tail). Chopping the tail (2"") at the back of the plastic wing saddle would make it possible with needle nose pliars and some twisting (I don't like it) Not enough (pull) space in the back to allow a clevis on the end of the wire. The best I can think of so far is to move control to just outside the tail as on most R/C planes. Looking for ideas !!!
Helitime is offline Find More Posts by Helitime
Reply With Quote