View Single Post
Old Nov 22, 2010, 10:54 AM
dbennettya is offline
Find More Posts by dbennettya
Registered User
Joined Apr 2009
1,574 Posts
I'm not sure what that would buy you other than a little COG change. You could use Align tail servo mounts if the boom is the same diameter on the B400. My T-Rex 250se uses two boom mounted servo clamps and it is real secure, but they are beefier than the rear B400 mount so I wouldn't try using two of those EFLH1458 mounts.

YMMV, Don

Quote:
Originally Posted by hedgeheli View Post
Anyone have any good solutions to this?

I was planning on just buying another rear servo mount EFLH 1458 and then cut down the current tail linkage pushrod. The reason I am hesitating is I dont think it would be very secure.

Anyone got good piccys or some advice.

Cheers
dbennettya is offline Find More Posts by dbennettya
Reply With Quote