Thread: Discussion RSSI pins for various receivers
View Single Post
Old Nov 22, 2010, 06:22 AM
dragant is offline
Find More Posts by dragant
Registered User
dragant's Avatar
Belgrade, Serbia
Joined May 2010
521 Posts
Quote:
Originally Posted by bakchos View Post
I question tho, when the Transmitter is off, i have 0.87 Volt, when on at 100 % i get 1.07 Volt, and when the transmitter is in the microwave i get 1.25 Volt.

So it looks like it get higher when strenght is weak, but gets lower when turned off, is that common ?

Here is the pictures,









Hope it helps.
It helps a lot. Thanks Does it works for you?
Where do you connect this on the Remzibi board?

One more question for you (please)
I have 6ch Flysky receiver for my FPV plane and would like to have rssi on my osd screen. This Rx have same A7105 chip and I see where you soldered one wire, but where should I solder second whire on my board?







dragant is offline Find More Posts by dragant
Reply With Quote