Thread: Discussion HobbyKing Fox EPO Glider 2.32M
View Single Post
Old Nov 21, 2010, 06:05 PM
birdofplay is offline
Find More Posts by birdofplay
Registered User
birdofplay's Avatar
United States, IN, Indianapolis
Joined Dec 2005
9,519 Posts
I was hoping that SOMETHING would stick to the wall, if I threw enough stuff :-)

Look it there, you did good :-)

So you ran the original bolt UP a bit further to expose the
drilled and ground end - is that it ?
Then drilled out the original threaded plastic in the stab so the exposed bolt
could slide onto the stab and then get Pinned !

Doing as much as possible with the least amount of parts and work !!!

I like it !

Um maybe a large. thin. plastic, washer between the stab and Pin
would add a little stability ???

A little white packing tape over that servo and it will disappear too !

Bob
birdofplay is offline Find More Posts by birdofplay
Reply With Quote