Thread: Discussion XC#10 in a series, Giant Icon?
View Single Post
Old Nov 20, 2010, 01:25 AM
G Norsworthy is offline
Find More Posts by G Norsworthy
Master of the Wind
G Norsworthy's Avatar
United States, CA, San Jose
Joined Sep 2008
1,289 Posts
Two nights fighting with the CNC foam cutter using up very expensive time in the garage and I saw where this was headed. I see the potential but not for someone on a tight schedule. The CNC cutter was relegated to the dustbin of history and I made a quick contact with JuzWuz, who went above and beyond what anybody would expect and got me templates in the mail. Tonight we blocked out all the foam and I walked out with the Feathercut. If the Ikea table is built straight I only need to go on a quest for massive weight. If not, I go into work where there is an ultra flat table and plenty of stainless steel junk lying around to keep the corners down. Spent the day looking over Phil's old posts and I think I am ready to cut. Will try a layout on the apartment floor for a quick pic if we get a break in the rain tomorrow. While waiting for the templates I will research the materials needed to make the RDS and order a few remaining odds and ends like mylar.
G Norsworthy is offline Find More Posts by G Norsworthy
Reply With Quote