View Single Post
Old Nov 14, 2010, 08:19 PM
DCourt is offline
Find More Posts by DCourt
Registered User
Joined Nov 2010
10 Posts
Quote:
Originally Posted by garymcc View Post
With the BEVRC v2 it appears the control rod tubes are installed internally in the fuselage. Is it possible to glue the full length of these tubes to the fuselage and use them to stiffen the fuse like Multiplex does with the "snakes" on the Easy Glider Pro? This would result in essentially a free fuselage reinforcement.


I was thinking the same thing. I added the carbon fiber rod to the outside 5-6" before it connects to the rudder, but was thinking you could remove the clear tube all together and use the carbon fiber rod throughout. It is connected to the fuse a few times internally, and the connections are glued. I tested mine before I glued the 2 halves together and there is no flex internally, but it's not all together either. I may re-glue the clear tubes inside to insure they don't move.
DCourt is offline Find More Posts by DCourt
Reply With Quote