View Single Post
Old Nov 11, 2010, 12:35 PM
jarel design is offline
Find More Posts by jarel design
Registered User
jarel design's Avatar
Southern Oregon
Joined Apr 2004
1,908 Posts
EyePod Inner Structure:

Your EyePod kit is complete and includes a 3mm thick foam sheet used to create the inner turret ball structure. Print the template sheet (photo attachment #1), on your home computer/printer. Double check for any distortion and confirm correct size of your print by measuring the included ruler/scales. (The measurements are in inches.)

NOTE: The template here is for the Standard EyePod ONLY! There is a different set of parts for the Aerodynamic EyePod!

#1: Full size pattern and templates for the foam sheet inner structure. Cut them out from the foam sheet supplied with your EyePod kit.

#2: Using FOAM SAFE CA and Kicker, assemble the inner structure as shown in the photos. Make sure your sides butt up against the bottom of the “Top” ball turret frame. Height is fairly critical here.

#3: When your Frame is completed, it should look like this (kind of!), I pressed down too far and the space between the bottom of the ball and the insert step in the outer shell base is a hair too small. You can see how I pressed the top foam sheet frame so hard that the outer sides are slanted in… This is what NOT to do…

#4: DRY FIT your inner frame structure and test attaching the top shell. We’ll be gluing the inner structure in place in the next post.
jarel design is offline Find More Posts by jarel design
Reply With Quote