View Single Post
Old Nov 09, 2010, 02:58 PM
jarel design is offline
Find More Posts by jarel design
Registered User
jarel design's Avatar
Southern Oregon
Joined Apr 2004
1,908 Posts
More "Inside Information" with photos including "kit contents"

It's just been crazy here!

Totally amazed at the response to this camera mount... THANK YOU!!!!!

Still creating final high temp tooling, but I've receieved a lot of emails asking what makes this so special? How does it work? What's inside?

Welll since I don't have a lot of time at the moment, and they say a picture is worth a thousand words, here's a few "pictures"! lol!

Basically there's an internal ball cradle that isolates the ball from the outer shell. a secondary piece of thin foam rubber serves double duty: It helps isolate the camera even further from the outer shell and...

The black foam rubber helps hold the camera in place where you position it...

The black elastic cord supplies the "spring tension" that keeps it all in place... The white piece of plastic tube (slid on the elastic in the kit contents photos) is cut and used to secure th ends of th elastic during final assembly...

I doubt it would take most builders more than an hour to put this together... Especially once I complete and post the build thread for all three versions...

Thanks again for your support!
I'll be back soon!

Richard
jarel design is offline Find More Posts by jarel design
Reply With Quote