View Single Post
Old Nov 09, 2010, 04:04 AM
alll is offline
Find More Posts by alll
Joined Sep 2004
1,535 Posts
Originally Posted by DarkHeli View Post
Well the Y6 is at about 12". My quad had trex 500 booms for arms, that was quite big. ( I may make another big quad in the future, I liked the stability. )

I would love to do that, but AVR does not support my programmer. Is there a DIY serial one that can be made to run on AVR?

Also: Is it possible to insert a HH tail gyro between receiver and controller board channel 4 rudder to gain HH mode? Although the rate mode is flyable, I would prefer HH.
I use AVR-Studio to compile and eXtreme burner to upload the hex into the atmega.
alll is offline Find More Posts by alll
Reply With Quote