View Single Post
Old Nov 06, 2010, 12:52 PM
UNGN is offline
Find More Posts by UNGN
Power Wheels Guru
UNGN's Avatar
Southlake, TX
Joined Jan 2008
7,327 Posts
Quote:
Originally Posted by Adventurer View Post
Thanks for the response UNGN,
That make sense now as when I go through the entire process minus the stick programming, the flaps work in reverse from each other.
I have gone through the manual of the DX6i multiple times and I can't seem to find any info on how to do the stick programming. I see on the picture provided by Modfly the step with the elastic but can't figure it out. Any input?
To switch the brick to different modes, Bind the brick to the TX (preferably a RTF TX or a TX with no mixes or channel swaps), then UNPlug the brick.

With the TX on, move the sticks to the positions shown in the manual for the mode TX you have (Mode 2 or mode 1)

Plug in the brick.

After 5 seconds or so, it should flash 3 times and the servos will move (if you are changing directions of that servo and the Stick logic is operating that servo)

The Stick logic is in the AR6400 manual pdf file.
UNGN is offline Find More Posts by UNGN
Reply With Quote