View Single Post
Old Oct 27, 2010, 03:07 PM
freechip is offline
Find More Posts by freechip
Air, Ground & Water
freechip's Avatar
Canada, ON, Rockland
Joined Aug 2008
26,841 Posts
OK just like the DX6i you need to create one MIX to mix the AIL channel to the GEAR channel for proper aileron movement and you also need to create a second mix for the flaps FLAP to GEAR. With the DX8 programming the Second mix can be done 2 ways.
#1 MIX AX1 to gear or #2 MIX FLAP to GEAR. both do the same thing.

Where the DX6i failed to do well was because the DX6i could not disable or INH the gear switch and left the channel NOT centered.

I taught for one second that you could use only one mix and tell the radio to simply MIX the gear channel to the AUX1 channel and mimic what it does since at the end of the day and on the receiver its the same channel that does AILERON and FLAPS when DUAL AILERON/FLAPERON is used.
freechip is offline Find More Posts by freechip
Last edited by freechip; Oct 27, 2010 at 03:35 PM.
Reply With Quote