View Single Post
Old Oct 27, 2010, 11:37 AM
freechip is offline
Find More Posts by freechip
Air, Ground & Water
freechip's Avatar
Canada, ON, Rockland
Joined Aug 2008
26,836 Posts
Nice of you to post this info, its been discussed over & over before that is was do-able with the AR500 as long as you were not trying to do it with the DX6i.

Since the DX6i does not have the ability to disable as switch it made it impossible to get it to work properly with the limited 2 mix capability of the DX6i but very pssible with the DX7 and of course the DX8.

I need to confirm this tonight BUT I think it could be done simply with ONE mix. If disabling the GEAR switch centers the channel then all you need is to MIX AUX channel to the gear. Just need to gear to mimic the AUX channel.

Trying to wrap my head around why you need to mix both AIL to GEAR and AUX to GEAR.

You are missing one input value in your mixing when you value 100% you do not specify if its for UP and or DN

Using the SERVO MONITOR screen when creating mixes helps alot when trying to figure out stuff. Would of probably saved you time over the phone.
freechip is offline Find More Posts by freechip
Last edited by freechip; Oct 27, 2010 at 11:43 AM.
Reply With Quote