Thread: Discussion T-Wii
View Single Post
Old Oct 19, 2010, 02:33 PM
signguy is offline
Find More Posts by signguy
Registered User
signguy's Avatar
Swansea, Massachusetts
Joined Dec 2004
2,088 Posts
Hey Tim

Here are the pictures of my board. Its the RBBB clone, with the WM+ only.

The receiver has channels 1,2,3 using a single servo plug across the three signal pins, and an extra pin for ch4. I had to bring one ground to the receiver for one of the speed controls. I ran my BEC into the receiver, then a plug from a spare channel out to the RBBB. Hope these help.
BobD
signguy is offline Find More Posts by signguy
Reply With Quote