View Single Post
Old Oct 19, 2010, 11:25 AM
jarel design is offline
Find More Posts by jarel design
Registered User
jarel design's Avatar
Southern Oregon
Joined Apr 2004
1,908 Posts
Great info all!

Thank you!

Possible mold material instead of JB Weld: I use TC-1630 made by BJB Enterprises (Orange County, Southern California and distributed by Stephenson Pattern Supply in Portland Oregon(and others)... This stuff comes in a gallon kit (actually much more than a gallon) is pretty easy to pour, provides a fairly long pot life, holds GREAT detail, easy to pour, holds up to heat, is machinable (easily sanded) and hold up over time... and, it's under $100 for about a gallon and a half.... Obtainable in smaller sizes through Burman Industries in Van Nuys California (special effects supply house)...

Might be worth investigating...

Thanks again for all who are sharing here!

Best,
Richard
jarel design is offline Find More Posts by jarel design
Reply With Quote