View Single Post
Old Oct 13, 2010, 11:43 AM
Gadflyii is offline
Find More Posts by Gadflyii
Registered User
Joined Jan 2010
1,126 Posts
Discussion
4g6 refreash.... My first CP is finally getting tired; advice needed

As most of you know my first CP helicopter was my beloved 4G6. I have flown the hell out of it, crashed more times than I can count, and it has been a fantastic little heli with many hundreds of flights on it.

Well... She is just tired and the time has come to refreash and upgrade her to her former glory.

I need a new main motor, and would like to upgrade to something with more power since I am now doing basic 3D.

I would really like to go flybarless so it matches the rest of my fleet.

The servo set is brand new, and I have already replaced all of the bearings, and the entire tail section is brand new, but I would like to get some of the upgraded tail pieces.

I have not really been keeping up with the new developments on the 4g6 as I have been going though a divorce and have not had time. I really could use a good rebuild project, and I was hoping there would be one or two fellow 4g6 nuts out there that would help guide me a bit so I can buy some parts today and do the rebuild this weekend.

What 3 axis reciever should I get? I have 2801Pro TX's with the 2.2 firmware

What motor? What lipos? Should I jump to 2S?

What flybarless head?

Suggestions on the main rotors? Stock still the best? Tail rotors?



Many Many thanks in advance to you all.
Gadflyii is offline Find More Posts by Gadflyii
Reply With Quote