View Single Post
Old Sep 25, 2010, 11:01 PM
Prime_8 is offline
Find More Posts by Prime_8
Lawn dart pilot/builder
Prime_8's Avatar
N.L. Canada
Joined Jun 2010
2,337 Posts
i do it just in a 2d paint . my 3d max is at home .
lol
that was real draw pro.
i use it to make textures and such for my 3d models in computer games.

.
e deflection is how the both , elevons work. so down e pushes the top ball joints back, that pushes motor to down , and opposite for up E.
and l & r Al' is each ball puls or pushes , spinning in lower ball.
the bottom ball is just a special hinge. and the socket , is fixed relative to fuse .
but you can set it's length by turning on pushrod end . that sets trim for E mix.
..
forward sweep , i'm unsure about % sweep to tip chord lenght .. so reading .
Prime_8 is offline Find More Posts by Prime_8
Reply With Quote