View Single Post
Old Sep 06, 2010, 12:57 PM
skye is offline
Find More Posts by skye
Registered User
Joined Jul 2010
62 Posts
Quote:
Originally Posted by Xnaron View Post
I routed it...man those traces are small...I didn't have small enough drill bits and ended up losing some pads. I also made a mistake cutting the board out on the X. The board is offset +0.025 on the X and -0.025 on the Y on the bottom. I compensated the wrong way. Here is a pic...I could use this board but I think I'll make another when I get the right drill bit size.

edit: there are a couple of questionable traces as well... I might work on a 2 sided version of the board. The main problem I had is the via's under components. I might spend some time and try and modify the other through hole version...
Hi, just curious here, is there any reason not to etched out the wide portion of copper?
skye is offline Find More Posts by skye
Reply With Quote