View Single Post
Old Aug 31, 2010, 11:42 AM
everydayflyer is offline
Find More Posts by everydayflyer
Southern Pride
everydayflyer's Avatar
Haralson County GA. USA
Joined Oct 2004
34,852 Posts
Quote:
If you have been using a different charger to charge these LiPo's before you got the PL8, then chances are the over-voltage safety codes you received are due to the fact that the other charger over-charged the cells slightly.
Agree but the only time I have ever seen this happen is after charging on another charger and then doing a topping off(?) charge on the CellPro 10 or POWERLAB8. IMO it should not require any cycling to correct this jus a discharge as in using it or just discharging to Storage with the PL8. Next charge should be fine.

Charles
everydayflyer is offline Find More Posts by everydayflyer
Reply With Quote