Originally Posted by Rafa's CB100
I'm happy to report that I have adjusted my swash to blade grip linkages to 30.0mm, as AC had noted yesterday (they had been around 31.2mm). The result is that I now have zero degrees pitch at midstick, and -9 to 9* of pitch travel!! Woo hoo. Now if the rest of my parts would just get here, I could try to get back up in the air . . ..
ps The other thing I learned is that one full turn on those particular linkages changes it's length 0.25mm.
Hey R, you get it ! now you have +9-9 on pitch , lower linkage should be 28 ~ 28.5 mm or even 29mm depending on servos horn are all on same level.
Hope you'll get parts soon to get in the air again.
Actually i'm using these settings and heli is flying perfectly, really smooth aggressive flyer , no 3D test , only routine outdoor flight.
: Mode 2
: 1 Servo normal
: Elev - Revs; Aile - Revs; Thro - Norm; Rudd - Norm; Pit - Norm
: All 100% except Rudd 120%
: Gyrosens -> Auto -> 0: 79%, 1: 79% Hold:0
: Ele, Ail and Rudd D/R 100% ---All Exp +35%
: Thrcurv -> Nor: Linear(0-25-50-75-100) St1: 90% all across; St2: 100% all across
Pitcurv -> Linear in all modes (0-25-50-75-100)