Thread: Discussion Walkera 4F200 3 blade head
View Single Post
Old Aug 11, 2010, 09:21 PM
Alwayscrash is offline
Find More Posts by Alwayscrash
"you'll play to live "
Alwayscrash's Avatar
Canada, QC, Montreal
Joined Sep 2009
1,819 Posts
Quote:
Originally Posted by Rafa's CB100 View Post
Hi Guys,

I updated my curves to be the same as dkfuji's, then remeasured my pitch angles. I can see where the pitch angles with these curves are different, but the endpoints are the same, kinda like I had figured. Instead of 6.5* at mid stick, I now get 5*.

Just to confirm, if I'm not mistaken, I now need to adjust midstick to 0* for all 3 blades by adjusting the linkage lengths, right? Sorry I don't have more confidence in my theory, I just want someone to tell me I'm right before I go mucking with it. Thanks again,

Rafa
R, just leave upper linkages as stock ( from end to end=30mm), Make sure your are at Normal Mode, pitch curve is the default linear, that is a 45 degree straight line, parameters should be 0%, 50%, 100%. When you move throttle stick, you should see the main Blade will become an angle at -9 degree (0% throttle), +2 degree (50% throttle) and +10 degree (100% throttle), adjust lower ball link if needed.
This is as i've done on mine and it works flawlessly, don't know about you.
hope this help
Alwayscrash is offline Find More Posts by Alwayscrash
Reply With Quote