View Single Post
Old Aug 02, 2010, 08:40 PM
Scooter04 is offline
Find More Posts by Scooter04
Registered User
Scooter04's Avatar
Columbus, OH
Joined Jul 2007
161 Posts
Oh just thought about something on knife edge. Look to see if the servo linkage is "pulling" when knife edge is good and pushing when bad. May be servo stalling and/or linkage flexing. I think the same phenomenon contributes to weird elevator behavior. i will have a closer look at mine as well.

Nice little pull pull set up would be sweet.
Scooter04 is offline Find More Posts by Scooter04
Reply With Quote