Thread: Discussion General Ekranoplan Topic
View Single Post
Old Aug 02, 2010, 03:25 PM
RdsG is offline
Find More Posts by RdsG
Registered User
RdsG's Avatar
Hungary
Joined Jul 2009
258 Posts
Thanks. Perhaps I will reduce the angle of the motor with 5, but this high angle needed to protect the prop and the motor from possible damage, and to produce enough air injection in the same time. Perhaps it will reduce air flow separation over the wing too. And of course I will be consider it when I set the CG.

I use SolidWorks to design my models.

Gabriel
RdsG is offline Find More Posts by RdsG
Reply With Quote