View Single Post
Old Jul 18, 2010, 07:48 PM
Slaanesh is online now
Find More Posts by Slaanesh
Not enough hours in the day
Slaanesh's Avatar
Melbourne
Joined Feb 2009
2,460 Posts
Quote:
Originally Posted by ajbaker View Post
On mine, the weight is 14g with connectors (2mm). I think they lie about almost all of their motors.
I think you will find that the connectors weigh more than you think.
I was originally going to use 2mm connectors but when I weighed a complete set decided not too. I used a standard servo connector instead (which can be easily reversed to get the motor to spin the right direction).

Quote:
Originally Posted by Fisticuffs! View Post
Here are some pics or the aileron and battery hatch setup on my new FW.
Yes nice job. Are you planning on using the spinner?

Also, I'm just wondering, can you reverse the shaft of the HK 10g brushless outrunners (and for that matter the 5g outrunners)? If you can, I think by far the easiest and lightest way to mount these would be a little firewall directly at the very nose of the plane (where the 'scale engine' piece would go).
Slaanesh is online now Find More Posts by Slaanesh
Reply With Quote