View Single Post
Old Jul 12, 2010, 12:51 AM
Wisdumb is offline
Find More Posts by Wisdumb
Registered User
Wilsonville, OR
Joined Jun 2010
575 Posts
Update #4: I think the torque rod modification will work out great. The arms line up perfectly with the pre-drilled holes on the torque rod. The dimensions are almost identical! All I had to do was bore out the center to the same diameter as the torque rod, flatten a spot where the set screw seats and voila! So far there doesn't seem to be any clearance issues, even when the vertical stab is mounted on the fuse. Take a look:

YA F-16C Video Update #4 (3 min 54 sec)
Wisdumb is offline Find More Posts by Wisdumb
Reply With Quote