View Single Post
Old Jul 11, 2010, 10:42 AM
frankg is online now
Find More Posts by frankg
Registered User
Joined Dec 2004
4,158 Posts
The first part to glue to the sub decking is the transom covering board. This board will butt against the ends of the two already installed covering boards, making sure that the center line of the covering board is on the center line of the hull. Mark the inside edge of the cover board on the sub decking, and then apply the 12 minute epoxy glue to the area and install the covering board, taping and weighting in place. Once the glue has cured, remove the tapes and weights and carefully clean up any excess glue that may have come out the edge of the covering board. Reference drawing DWG #9 for locations of inlays.

frankg is online now Find More Posts by frankg
Reply With Quote